Dead End in middle of highway.

[bigbuilder]

So I was working on a highway connection at the edge of my area because I wanted to put in an intersection. I deleted hightway right up the the edge and tried to rebuild it and now I have a dead end that I can't get rid of no matter what I try. I bought the adjoining area to see if that would help but no, it's still in the middle of a fully built highway.

Any ideas what's going on here?

 

[Blais]

That's the indicator for one-way roads ending nowhere (highways are one-ways too). Remove one bit at the problematic site and take a close look to the arrows on the roads - there is surely one bit that is heading in the wrong direction. Should be easy to fix.

 

[bigbuilder]

I'm a bit of an idiot. You were right, there was a small part of highway going in the wrong direction. Thanks for the help

 

[WizoneDE]

they should add arrows at this place in red

had the same problem yesterday and it took time till I remember in which way I had draw the line.

Waiting for an upgrade feature to switch oneway directions of an already existing road

 

[Blais]

I'm a bit of an idiot. You were right, there was a small part of highway going in the wrong direction. Thanks for the help

We were all idiots at one point You're welcome.

 

[BStyles]

I did this with a diamond intersection. It worked, however cars had to make a u-turn at off-ramps. It was hilarious.

Also, as an added note, it appears that the lights for the highways are situated on the right. In the image, the lights switch from right to left.