• We have updated our Community Code of Conduct. Please read through the new rules for the forum that are an integral part of Paradox Interactive’s User Agreement.

Simog6

Second Lieutenant
18 Badges
Apr 19, 2016
107
14
  • Cities: Skylines - Snowfall
  • Cities: Skylines - Campus
  • Cities: Skylines Industries
  • Cities: Skylines - Parklife
  • Cities: Skylines - Parklife Pre-Order
  • Cities: Skylines - Green Cities
  • Cities: Skylines - Mass Transit
  • Cities: Skylines - Natural Disasters
  • Cities: Skylines - After Dark
  • Cities: Skylines
  • War of the Roses
  • Warlock: Master of the Arcane
  • The Showdown Effect
  • Crusader Kings II
  • Cities: Skylines Deluxe Edition
  • Age of Wonders III
  • Leviathan: Warships
  • Europa Universalis III
Hi

How can I force the buses to move to the right of the lane in stops? I tried to set the stop offset but bus stays on its lane.
To the right of this lane is the one for parked cars. I would like move on it.

Thanks
 
Hm that's strange, I haven't tested it myself yet, if you have a parking strip where the cars can park and then set the stop-offset this should actually work.

Question: What value did you use for the stop offset, it should be 3 for forward and -3 for backward.

On which lane did you choose stop type? park lane, vehicle lane or pedestrian lane? correct it must be on the predestrian, the stop type for bus should be "CAR" here.
 
Therefore, the road is a bit particular, take one side:Form center there is: a lane for cars, one only for tram, then there is a pedestrian island with the tram stop. Then another lane for cars where the bus (lane not dedicated) pass to stop on this I set the offset of 3 and Stop Type none (i'm usnig a vanilla lane)
After this tere is the parking lane , No offset and Stop Type Car, then the pedestrian No offset and Stop Type Car (vanilla options) Is it correct?

Another question. I do not understand what is the left and the right. They are calculated depending on 3D model or the tracing direction? Also know whether a negative / positive offset value to which direction corresponds

Thanks
 
Last edited:
So as far as the left and right is concerned, this is due to the attitude that you can also set the game for left-hand traffic, since in most countries there is right-hand traffic.

Going from the right-hand side of the road, you now drag a street in the editor from the left-hand side of the screen to the right-hand side of the screen, then the Untere Straße is the "Forward" and the Obere Straße is the "Backward", i. e. the opposite direction.

Can you show a screenshot of your street so that you can better understand how your street is built?

If you look at the street in the top view, and then drag a street from the bottom edge of the screen to the top edge of the screen, then the "Forward" is the right half of the street and the "Backward" is the left half of the street.

The stop offset must be set in the lane on which the bus normally drives, usually the outermost lane, e. g. the lane on the far right for a multi-lane road.
 
Last edited:
Thanks.
For the stops problem, I found the error this morning. In the parking lane I set Vehicle type on None and Stop on Car. Instead, they were set inverted.

Anyway, this is the road:
Screenshot 37.png
 
You have to set the parking lane to Car, otherwise cars will never park in this lane.

On the track where the bus is going, you set the stop-offset to stop at 3 or -3, it just depends on the direction, or better said, on which side the bus stop is, as soon as you then place a stop at this point some parking vehicles should disappear because this place is reserved for the bus.
 
You have to set the parking lane to Car, otherwise cars will never park in this lane.

On the track where the bus is going, you set the stop-offset to stop at 3 or -3, it just depends on the direction, or better said, on which side the bus stop is, as soon as you then place a stop at this point some parking vehicles should disappear because this place is reserved for the bus.

Yes, it was just the mistake I did. I did not set the type of vehicle but stop it in the parking lane. inverted the two parameters :)
Positive stop offset if the lane has, in turn, positive value and viceversa.